Categories
Flight Simulation

Short Landings in Flight Simulation with MSFS 2020

On approach for Île d'Orléans.
On approach for Île d’Orléans.

Today’s flight consists of two virtual short landings using the MSFS 2020 flight simulator (or as some call it, FS2020). We will be landing on Île d’Orléans and on the Battlefields Park.

First of all, I admit that the Cessna 170B’s windows are dirty. For realism, the designer Carenado left a little dirt here and there to show the wear and tear of this very old aircraft.

The picture above shows Île d’Orléans as seen from the Cessna. Since there is no landing strip but a golf club in the area, we will use the open fairways to land the aircraft. If there is a golfer on the course, I will open the window and yell, as is customary, “Fore!” (Falling Object Returning to Earth).

On final for Île d'Orléans
On final for Île d’Orléans

We are established on final for the small portion of open ground ahead. With 40 degrees of flaps, the stall speed is particularly low and the landing should not be too difficult.

On Île d'Orléans ready for take-off.
On Île d’Orléans ready for take-off.

Although the available strip was not very wide, it was long enough for the landing, the taxiing and the maneuvering to turn the aircraft 180 degrees for its take-off to Quebec City.

Airborne from Île d'Orléans with a Cessna 170B
Airborne from Île d’Orléans with a Cessna 170B

Back in the air, direction Quebec City. The take-off on soft ground requires about 20 degrees of flaps.

Enroute towards Quebec City.
Enroute towards Quebec City.

Quebec City is in sight. In the Cessna C-170B I flew in 1981 across Canada from St-Jean-sur-Richelieu to Edmonton, Alberta, there was no modern navigation aid installed on board as in the photo above, where the GPS helps the pilot find his way. The flight was flown using 14 VFR charts and nothing more. (If you are interested, click to read more about real-life flying stories on my blog).

Hôtel le Concorde and its revolving restaurant, visible on the right.
Hôtel le Concorde and its revolving restaurant, visible on the right.

We are now above the Plains of Abraham. On the picture above, on the right, you can see the Hotel le Concorde and its revolving restaurant. We will possibly disturb the quiet atmosphere of the meal as we fly by…

The MNBAQ and the Battlefields Park are in sight.
The MNBAQ and the Battlefields Park are in sight.

Above, straight ahead, the gray buildings represent a portion of the Musée National des Beaux-Arts de Québec (MNBAQ). A little further on is the open area of the Battlefields Park. In 1928, Lindbergh landed on that field to bring badly needed medicine for his friend Floyd Bennett. Can we normally land on the Battlefields Park, in the heart of Quebec City? Of course not. But that’s the beauty of a flight simulation; you can do whatever you want!

Cessna 170B on the Battlefields Park in Québec City.
Cessna 170B on the Battlefields Park in Québec City.

Once landed, the aircraft is allowed to decelerate gradually and then turned 180 degrees for the next takeoff. When winds are light, there is no need to worry about the direction of the takeoff.

Aerial view of Battlefield Parks with the Cessna 170B under MSFS 2020.
Aerial view of Battlefield Parks with the Cessna 170B under MSFS 2020.

Above, an aerial view of the Battlefields Park, with the virtual Cessna C-170B ready to take off again.

Partial view of Quebec City in flight simulation with MSFS 2020
Partial view of Quebec City in flight simulation with MSFS 2020

One last picture, this time with some additional buildings. The realism of the virtual scene with FS2020 is amazing!

I hope you enjoyed these two short flights. Whether you use the short landing technique for the Battlefields Park is really up to you, as there is enough space for a normal landing. But it is good to practice landing in the shortest distance possible. You never know when your engine will quit!

You can click on the following link for other challenging virtual flights   on my blog.

Categories
Flight Simulation

Flying in and out of Limberlost Ranch (CA21)

The following pictures show a virtual flight in United States. The trip is from KBLU ( Blue Canyon-Nyack) to Limberlost Ranch (CA21) then to Gansner Field (201). Landing and taking-off from Limberlost Ranch is a nice challenge.

For this flight simulation, I used the FSX flight simulator, the Carenado Cessna C-207 equipped with bush tires and REX clouds.

Airborne from KBLU.

The Cessna C-207 is airborne from the Blue Canyon-Nyack airport runway
The Cessna C-207 is airborne from the Blue Canyon-Nyack airport runway

Enroute from KBLU (5284 ft ASL) to Limberlost Ranch and it’s 1700 ft grass runway (1650 ft ASL and about 23 NM east of KBLU), you pass by the Nevada County airport (O17) that has also received a special treatment from ORBX.

It might be necessary to fly over the Limberlost Ranch airport before starting an approach, so that you have an idea of what to expect on final.

Over the Limberlost Ranch short and sloped runway
Over the Limberlost Ranch short and sloped runway

Limberlost Ranch has a sloped runway (in fact, a multiple slope runway). Part of it is asphalted, but most of it is grass. You make the approach for the grass section. Note that there is a fence on the side at the beginning of the runway. The virtual aircraft should not touch the field before it has passed the fence (for more realism).

The Cessna C-207 is on final for the Limberlost Ranch sloped runway
The Cessna C-207 is on final for the Limberlost Ranch sloped runway
Landing on the Limberlost Ranch short and sloped grass runway
Landing on the Limberlost Ranch short and sloped grass runway
The Cessna C-207 is parked at Limberlost Ranch for a few minutes
The Cessna C-207 is parked at Limberlost Ranch for a few minutes
Ready for take-off from the Limberlost Ranch runway
Ready for take-off from the Limberlost Ranch runway

With a bit of crosswind, taking-off from this short runway can be demanding. The aircraft feels really sloppy (and I mean it) and behaves more like a boat than a plane during the acceleration to get airborne. It is essential to avoid the line of trees on the left side of the runway. A bit of flaps is required as it is the norm for soft runway operations. Careful but essential use of the rudder will also make your take-off a success.

Aircraft airborne from the Limberlost Ranch runway
Aircraft airborne from the Limberlost Ranch runway

Enroute to Gansner Field.

Over the Gansner Field airport runway
Over the Gansner Field airport runway

Gansner Field is about 41 nm north of KBLU. The virtual airport is very well made and nestled in a valley. Coming in from KBLU, you need to pass 6000 ft mountains before diving for that 3419 ft asl asphalt runway.

The fully enjoy those virtual flights, it is suggested that you install the different layers of Orbx products (Global, Vector, Open LC) as well as the KBLU virtual scenery.

Have a good flight!

For more articles on flight simulation on my web site, click on the following link : Flight simulation

Categories
Real life stories as a flight service specialist (FSS): Inukjuak FSS

When in doubt, action is worth more than inaction.

(Precedent story: enroute toward the first posting: Inukjuak)

The Inukjuak soft sand runway, in 1982, and a balloon tires equipped Twin Otter, property of Austin Airways.
The Inukjuak soft sand runway, in 1982, and a balloon tires equipped Twin Otter, property of Austin Airways.

During my first working days as a flight service specialist (FSS) at the Transport Canada flight service station in Inukjuak (CYPH), in 1982, I received a radio call from a Twin Beech 200. The pilot of this aircraft registered in the United States indicated that he wished to land at Inukjuak for a short stopover. Several passengers were on board. I gave him the necessary air traffic services and followed its progress towards the airport, through subsequent radio communications.

It is assumed that a pilot wanting to land at an airport has prepared himself and knows the length and orientation of the runway, as well as its constitution (cement, asphalt, gravel, grass, sand). These are absolutely essential information, like ensuring that there is enough fuel on board the aircraft. This makes the difference between an accident and a successful landing. I doubted that Inukjuak, with its soft sand runway, was suited for an aircraft like the Beech 200.

Being a pilot myself, I was uncomfortable to ask him if he was aware of the characteristics of the Inukjuak runway, because this was such basic information. Moreover, having no experience as a flight service specialist yet, I considered unimaginable that in the early days of a new career, I had to deal with a pilot that was not adequately prepared, and would soon put his life and the lives of his passengers in danger.

I kept on thinking that if the pilot was responsible for this type of aircraft, he must have had hundreds, if not thousands of hours of flying experience. It would be like saying: “Don’t you think that the plane is too big for your abilities?

The aircraft was now on final for the runway, a few miles away. I decided to ask the fateful question: “Are you aware that you are about to land on a 2000 feet soft sand runway?”  The pilot softly said: “OK, we’ll do a missed approach and will head somewhere else. Is Kuujjuarapik acceptable for us? “I answered positively and in the following seconds, the airplane overshot the runway and headed southward for the next airport.

From that day and the following decades, I vowed to never take anything for granted. When in doubt, action is worth more than inaction…

(Next story: A visit at the Inukjuak flight service station (1982))

For more real life stories of a FSS in Inukjuak, click on the following link: Flight service specialist (FSS) in Inukjuak